Problem Symptoms Table
POWER WINDOW CONTROL SYSTEM
PROBLEM SYMPTOMS CHART
| Symptom | Suspected area | See |
|---|---|---|
| Power window does not operate with multiplex network master switch operation | 1. ECU-B, ECU-IG, PWR fuse | - |
| 2. MULTIPLEX NETWORK MASTER SWITCH CIRCUIT (POWER SOURCE) | ||
| 3. POWER WINDOW REGULATOR MOTOR CIRCUIT | ||
| 4. Multiplex network master switch | - | |
| Power window does not operate with multiplex network switch operation (front passenger side) | 1. PWR fuse | - |
| 2. MULTIPLEX NETWORK SWITCH CIRCUIT (POWER SOURCE) | ||
| 3. POWER WINDOW REGULATOR MOTOR CIRCUIT (FRONT PASSENGER SIDE) | ||
| 4. Multiplex network switch (front passenger side) | - | |
| Power window does not operate with multiplex network switch operation (rear LH side) | 1. PWR fuse | - |
| 2. MULTIPLEX NETWORK SWITCH CIRCUIT (POWER SOURCE) | ||
| 3. POWER WINDOW REGULATOR MOTOR CIRCUIT (REAR LH SIDE) | ||
| 4. Multiplex network switch (rear LH side) | - | |
| Power window does not operate with multiplex network switch operation (rear RH side) | 1. PWR fuse | - |
| 2. MULTIPLEX NETWORK SWITCH CIRCUIT (POWER SOURCE) | ||
| 3. POWER WINDOW REGULATOR MOTOR CIRCUIT (REAR RH SIDE) | ||
| 4. Multiplex network switch (rear RH side) | - | |
| AUTO UP/DOWN function does not operate on driver side | 1. DIAGNOSIS CHECK | |
| 2. POWER WINDOW REGULATOR MOTOR RESET | ||
| 3. Multiplex network master switch | - | |
| 4. Wire harness | - | |
| AUTO UP/DOWN function does not operate on any door side except driver sides | 1. DIAGNOSIS CHECK | |
| 2. POWER WINDOW REGULATOR MOTOR RESET | ||
| 3. Multiplex network master switch | - | |
| 4. Wire harness | - | |
| Remote UP/DOWN function does not operate | 1. DATA LIST / ACTIVE TEST | |
| 2. Multiplex network master switch | TERMINALS OF ECU | |
| 3. Multiplex network body ECU | - | |
| 4. Wire harness | - | |
| Power window can be operated after ignition switch is turned off even if operated conditions are not met | 1. Front door courtesy switch | TERMINALS OF ECU |
| 2. Wire harness | - | |
| AUTO UP operation does not fully close power window (Jam protection function is activated) | 1. POWER WINDOW REGULATOR MOTOR RESET | |
| 2. Check & Clean Glass run | - | |
| 3. Multiplex network master switch | - |