Steering Sensor: Installation
- INSTALL STEERING ANGLE SENSOR
- Install the steering angle sensor to the spiral cable sub-assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:- Engage the claws securely.
- Do not damage the claws.
- Install the steering angle sensor to the spiral cable sub-assembly.
- INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH STEERING ANGLE SENSOR (See REMOVAL )
- POINT FRONT WHEELS FACING STRAIGHT AHEAD
- INSTALL STEERING COLUMN COVER (for Manual Tilt) (See INSTALLATION )
- INSTALL STEERING COLUMN COVER (for Power Tilt and Power Telescopic) (See INSTALLATION )
- CENTER SPIRAL CABLE (See INSPECTION )
- INSTALL STEERING WHEEL ASSEMBLY (See INSTALLATION )
- INSTALL STEERING PAD (See REMOVAL )
- INSTALL STEERING WHEEL NO.2 COVER LOWER (See INSTALLATION )
- INSTALL STEERING WHEEL NO.3 COVER LOWER (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- INSPECT SRS WARNING LIGHT
(See TERMINALS OF ECU )
- PERFORM INITIALIZATION
Some systems need initialization after reconnecting the negative battery cable.
(See INITIALIZATION )