Data List/Active Test

HINT:

Using the hand-held tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

1. Connect the hand-held tester to the DLC3.
2. Turn the ignition switch ON.
3. Read the DATA LIST on the tester's screen.

   Standard: 

   Transponder key ECU assy: 

   ITEM NORMAL CONDITION TABLE
   
   

   Item	Measurement Item/Display (Range)	Normal Condition	Diagnostic Note
   KEY SW	Key unlock warning switch signal /ON or OFF	ON: Key is in IG key cylinder OFF: No key is in IG key cylinder	-

   Multiplex network boor ECU front LH: 

   ITEM DIAGNOSTIC NOTE
   
   

   Item	Measurement Item/Display (Range)	Normal Condition	Diagnostic Note
   LOCK POS SW	Door unlock detection switch signal /ON or OFF	ON: Door is unlocked OFF: Door is locked	-
   COURTESY SW	Door courtesy switch signal /ON or OFF	ON: Door is open OFF: Door is closed	-

   Multiplex network boor ECU front RH: 

   ITEM DIAGNOSTIC NOTE
   
   

   Item	Measurement Item/Display (Range)	Normal Condition	Diagnostic Note
   LOCK POS SW	Door unlock detection switch signal /ON or OFF	ON: Door is unlocked OFF: Door is locked	-
   LOCK POS SW	Door courtesy switch signal /ON or OFF	ON: Door is open OFF: Door is closed	-

HINT:

Performing the hand-held tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time.

The DATA LIST can be displayed during the ACTIVE TEST

1. Connect the hand-held tester to the DLC3.
2. Turn the ignition switch ON.
3. Perform the ACTIVE TEST according to the display on the tester.

   Multiplex network boor ECU front LH: 

   ITEM DIAGNOSTIC NOTE
   
   

   Item	Test Details	Diagnostic Note
   DOOR LOCK	Operate door lock motor OFF/LOCK/UNLOCK	-