On-Vehicle Inspection

1. Check that the passenger side power window operation is disabled when the window lock switch of the power window master switch is pressed.
2. Check that the passenger side power window can be operated when the window lock switch is pressed again.
   Fig 1: Chekcing Window Lock Switch

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Check that the driver side power window operates as follows:

   OK: 

   DRIVER SIDE POWER WINDOW OPERATION
   
   

   Condition	Master Switch	Switch Operation	Power Window
   Ignition switch ON	Driver side	Pulled halfway up	UP (Closed)
   Ignition switch ON	Driver side	Pushed halfway down	DOWN (Open)

2. Check that the passenger side power window operates as follows:

   OK: 

   Fig 2: Passenger Side Power Window Operation Table

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Check that the driver side power window operates as follows:

   OK: 

   DRIVER SIDE POWER WINDOW OPERATION
   
   

   Condition	Master Switch	Switch Operation	Power Window
   Ignition switch ON	Driver side	Pulled fully up	AUTO UP (Fully closed)
   Ignition switch ON	Driver side	Pushed fully down	AUTO DOWN (Fully open)

2. Check that the passenger side power window operates as follows:

   OK: 

   Fig 3: Passenger Side Power Window Operation Table

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Check the passenger side power window operates as follows:

   OK: 

   Fig 4: Passenger Side Power Window Operation Table

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Check the passenger side power window operates as follows:

   OK: 

   Fig 5: Passenger Side Power Window Operation Table

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

• The jam protection function prevents any part of your body from getting caught by accident between the door frame and the door glass during power window operation.
  Fig 6: Checking JAM Protection Function

  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Check that the door glass goes down by approximately 50 mm (1.97 in.) right when something gets caught between the door frame and door glass during power window operation. However, when the opening between the roof panel and the door glass is less than 200 mm (7.87 in.), the door glass continues to go down and does not stop until an opening of 200 mm (7.87 in.) is achieved. Operative conditions:
   • AUTO UP
   • AUTO UP/MANUAL UP function after the ignition switch is turned OFF
   • MANUAL UP function using the driver side door lock key cylinder

1. Check that all power windows operate as follows, when the key is inserted into the driver side door lock key cylinder.

   OK: 

   MANUAL UP/DOWN FUNCTION USING DRIVER SIDE DOOR LOCK KEY CYLINDER
   
   

   Condition	Key Operation	Position/Operation
   No key in ignition key cylinder	Turned left (LOCK) for more than 2.0 sec.	Driver and passenger side power windows/UP
   No key in ignition key cylinder	Turned right (UNLOCK) for more than 2.0 sec.	Driver and passenger side power windows/DOWN

1. Check that all power windows operate as follows when operating the transmitter.

   OK: 

   Fig 7: Power Windows Operation Table (Operating Transmitter) Table

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. When both of the following condition are fulfilled, check that the power windows can be operated even after the ignition switch is turned OFF.
   1. Within 43 seconds after the ignition switch is turned OFF.
   2. The front doors are closed.