Outer Rear View Mirror ASSY: Replacement
HINT:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- Use the same procedures for the RH side and LH side.
- The procedure listed below are for the LH side.
- REMOVE FRONT DOOR TRIM BOARD SUB-ASSY LH (See OVERHAUL
)
- Remove the power window regulator master switch.
- Remove the door inside handle bezel No. 2 LH.
- Remove the front door window upper bracket garnish LH.
- Remove the front door trim board sub-assy LH.
- REMOVE OUTER REAR VIEW MIRROR ASSY LH
- Disconnect the connector and remove the clamp.
- Remove the 3 bolts and outer rear view mirror.
- REMOVE OUTER REAR VIEW MIRROR SUB-ASSY LH
- Insert the cloth between the mirror and mirror body. Wrap the mirror in the cloth.
- Pull up the lower side of the cloth and disconnect the mirror joint.
- Pull up the mirror and remove it.
- Using a small screwdriver, disconnect the 2 connectors.
- REMOVE OUTER MIRROR COVER LH
- Remove the 4 screws.
- Detach the claw and remove the visor rim.
- Remove the protect cover LH.
- Detach the 3 clamps and remove the outer mirror cover.
- INSTALL OUTER MIRROR COVER LH
- Install the mirror cover as shown in Fig 9.
- Install the protect cover LH.
- Install the visor rim and attach the claw.
- Install the 4 screws.
- After installing the outer mirror cover, check that there is no gap between the cover and mirror visor rim.
HINT:
If there is a gap between the cover and visor rim, noises may occur during driving.
- INSTALL OUTER REAR VIEW MIRROR SUB-ASSY LH
- Connect the black connector to the terminal with the "B" engraving next to it.
- Connect the white connector to the terminal with the "W" engraving next to it.
- Install the mirror as shown in Fig 14.
- INSTALL OUTER REAR VIEW MIRROR ASSY LH
- Install the mirror with the 3 bolts.
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
- Install the clamp.
- Connect the connector.
- Install the mirror with the 3 bolts.