Light Control Rheostat: Installation

INSTALL LIGHT CONTROL RHEOSTAT
1. Engage the 2 claws and install the light control rheostat.
INSTALL NO. 1 SWITCH HOLE BASE
1. Connect each connector.
  
  Fig 1: Identifying Claws On Light Control Rheostat
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 4 clips and install the No. 1 switch hole base.
INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See INSTALLATION )
INSTALL SIDE INSTRUMENT PANEL LH (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM COVER LH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION )

Fig 2: Identifying Clips On No. 1 Switch Hole Base
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002