LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> ES 350 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - System & Component Testing, Removal, Inspection & Installation >> Accelerator Pedal >> On-Vehicle Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

  1. CHECK ACCELERATOR PEDAL ROD 
    1. Measure the voltage.
      1. Connect the Techstream to the DLC3.
      2. Turn the engine switch on (IG).
      3. Turn the Techstream on.
      4. Select the menu items: Powertrain / Engine / Data List / Accelerator Position NO. 1, Accelerator Position NO. 2.
      5. Operate the accelerator pedal, and then check that the Accelerator Position NO. 1 and Accelerator Position NO. 2 values are within the specifications.

        Standard Voltage (Accelerator Position NO. 1) 

        ACCELERATOR PEDAL CONDITION SPECIFIED CONDITION CHART

        Accelerator Pedal Condition Specified Condition
        Released 0.5 to 1.1 V
        Depressed 2.5 to 4.5 V

        Standard Voltage (Accelerator Position NO. 2) 

        ACCELERATOR PEDAL CONDITION SPECIFIED CONDITION CHART

        Accelerator Pedal Condition Specified Condition
        Released 1.2 to 2.0 V
        Depressed 3.4 to 5.0 V

        If the result is not as specified, check the accelerator pedal rod, wire harness or ECM.

scientia non olet · About LEMON Manuals