Inspection Procedure
WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When replacing the brake actuator assembly, perform zero point CALIBRATION
.
- CHECK ABS CONTROL SYSTEM
- Clear the DTC (See DTC CHECK / CLEAR ).
- Turn the engine switch on (IG).
- Check if the same DTC is recorded (See DTC CHECK / CLEAR
).
Result
RESULT CHARTCondition Proceed to DTC (ABS control system DTC) is not output A DTC (ABS control system DTC) is output B
B: REPAIR CIRCUIT INDICATED BY OUTPUT DTC (See DIAGNOSTIC TROUBLE CODE CHART )
A: Go to Next Step
- RECONFIRM DTC
- Turn the engine switch off.
- Clear the DTC (See DTC CHECK / CLEAR ).
- Turn the engine switch on (IG).
- Check if the same DTC is recorded (See DTC CHECK / CLEAR
).
Result
RESULT CHARTCondition Proceed to DTC (43) is not output A DTC (43) is output B
B: REPLACE BRAKE ACTUATOR ASSEMBLY
A: CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION)