Inspection Procedure

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT RADIO RECEIVER

Disconnect the radio receiver connectors.

Measure the resistance according to the value(s) in the table below.

Standard resistance

RESISTANCE SPECIFICATION

Tester Connection	Condition	Specified Condition
ATX+ - ATX-	Always	60 to 80 Ω

Fig 1: Identifying Radio Receiver Connector Terminals

NG: REPLACE RADIO RECEIVER

OK: Go to Next Step

CHECK HARNESS AND CONNECTOR
HINT:

For details of the connectors, refer to the "TERMINALS OF ECU ."
1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.
  1. Disconnect all connectors in all AVC-LAN circuits.
  2. Check for an open or short in all AVC-LAN circuits.
    OK: There is no open or short circuit.
    
    Fig 2: AVC-LAN Wiring Diagram
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE