Network Gateway Ecu: Installation

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL NETWORK GATEWAY ECU
1. Install the network gateway ECU with the nut.
  
  Fig 1: Locating Network Gateway ECU Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the connector.
  
  Fig 2: Locating Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the certification ECU with instrument panel wire with the bolt and 2 nuts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 3: Identifying Network Gateway ECU Bolts And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL RH (See INSTALLATION )
INSTALL SIDE INSTRUMENT PANEL RH (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM COVER RH
HINT:

Use the same procedure for the RH side and the LH side (See INSTALLATION ).
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure for the RH side and the LH side (See INSTALLATION ).
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).
INSPECT FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (See ON-VEHICLE INSPECTION )
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )