Steering Pad Switch: Installation

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING PAD SWITCH ASSEMBLY
1. Engage the 4 claws.
2. Install the steering pad switch assembly with the 2 screws.
  Torque: 2.4 N*m (25 kgf*cm, 21 in.*lbf)
3. Connect the connector to the spiral cable.
Fig 1: Locating Steering Pad Switch Connector And Screws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING PAD (See INSTALLATION )
INSTALL LOWER NO. 3 STEERING WHEEL COVER (See INSTALLATION )
INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )