Inspection Procedure

1. Initialize the power window regulator motor assembly (applicable location) (See CUSTOMIZE PARAMETERS  ).
2. Check if the power window AUTO UP/DOWN function operates normally.

   OK: 

   AUTO UP/DOWN function operates normally. 

NG : END (PROBLEM DUE TO INITIALIZATION FAILURE) 

OK : Go to Next Step 

1. Check if the jam protection function operates normally for the applicable power window.

   HINT:

   The jam protection function will not operate within 4 mm (0.157 in) of the fully closed position.

   OK: 

   Jam protection function operates normally. 

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   OK	A
   NG (Front LH side power window)	B
   NG (Front RH side power window)	C
   NG (Rear LH side power window)	D
   NG (Rear RH side power window)	E

B : REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See REMOVAL )

C : REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH  (See REMOVAL )

D : REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See REMOVAL )

E : REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH  (See REMOVAL )

A : END