Inspection Procedure

1. Turn the engine switch on (IG) and initialize the power window regulator motor (See CUSTOMIZE PARAMETERS  ).

1. Turn the engine switch off.
2. Wait for at least 10 seconds, and then turn the engine switch on (IG).
3. Check for DTCs.

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   DTC Is not output	A
   DTC output from front LH motor	B
   DTC output from front RH motor	C
   DTC output from rear LH motor	D
   DTC output from rear RH motor	E

B : REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See REMOVAL )

C : REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH  (See REMOVAL )

D : REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See REMOVAL )

E : REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH  (See REMOVAL )

A : END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)