Inspection Procedure
NOTE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (see INITIALIZATION
).
- CHECK DTC FOR VGRS SYSTEM
- Clear the DTC (see DTC CHECK/CLEAR ).
- Check for the DTC (see
DTC CHECK/CLEAR
).
Result
RESULT REFERENCEDisplay (DTC Output) Proceed To DTC (VGRS system) Is not output A DTC (VGRS system) Is output B (see DIAGNOSTIC TROUBLE CODE CHART )
B : REPAIR VGRS SYSTEM ACCORDING TO DTC OUTPUT
A : Go to Next Step
- RECONFIRM DTC
- Clear the DTC (see DTC CHECK/CLEAR ).
- Turn the engine switch on (IG).
- Check if the same DTC is recorded (see DTC CHECK/CLEAR
).
Result
RESULT REFERENCEDisplay (DTC Output) Proceed To DTC (C1289/41) Is not output A DTC (C1289/41) Is output B
B : Go to step 1
A : END