Inspection Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Select the following menu items: Powertrain/Engine and ECT/Trouble Codes.
5. Read the DTCs.

   Result 

   DTC OUTPUT REFERENCE
   
   

   Display (DTC Output)	Proceed to
   P011B	A
   P011B and other DTCs	B

   HINT:

   If any DTCs other than P011B are output, troubleshoot those DTCs first.

B : GO TO DTC CHART  (See DIAGNOSTIC TROUBLE CODE CHART )

A : Go to next step 

1. Leave the vehicle for 7 hours or more.

   HINT:

   It is necessary to leave the vehicle for 7 hours or more to duplicate the DTC detection conditions.

2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG).
4. Turn the Techstream on.
5. Select the following menu items: Powertrain/Engine and ECT/Data List/Intake Air.
6. Read the value displayed on the Techstream.

   OK: 

   Difference between the intake air temperature and the actual outside air temperature is within 10°C (18°F). 

   HINT:

   Temperature readings on the vehicle's outside temperature gauge (if equipped) are not suitable for comparing to the IAT reading. The outside temperature gauge has a significant delay built in to prevent temperature swings from being displayed on its display. Use an accurate thermometer to determine the outside air temperature.

NG : REPLACE MASS AIR FLOW METER 

OK : Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Select the following menu items: Powertrain/Engine and ECT/Data List/Coolant Temp.
5. Read the value displayed on the Techstream.

   OK: 

   The difference between the coolant temperature and the actual outside air temperature is within 10°C (18°F). 

   HINT:

   If the result is not as specified, check that there are heat sources such as a block heater in the engine compartment.

NG : REPLACE ENGINE COOLANT TEMPERATURE SENSOR 

OK : REPLACE ECM  (See REMOVAL )