Crankshaft Position Sensor: Installation

INSTALL CRANKSHAFT POSITION SENSOR
1. Apply a coat of engine oil to the O-ring of the sensor.
2. Install the sensor with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
3. Connect the crankshaft position sensor connector.
  
  Fig 1: Identifying Crankshaft Position Sensor Connector With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADJUST COMPRESSOR OIL (See INSTALLATION )
INSTALL COOLER COMPRESSOR ASSEMBLY (for 2WD) (See INSTALLATION )
TEMPORARILY TIGHTEN COOLER COMPRESSOR ASSEMBLY (for 4WD) (See INSTALLATION )
INSTALL OIL FILTER BRACKET SUB-ASSEMBLY (for 4WD) (See INSTALLATION )
INSTALL OIL FILTER BRACKET (for 4WD) (See INSTALLATION )
TIGHTEN COOLER COMPRESSOR ASSEMBLY (for 4WD) (See INSTALLATION )
CONNECT DISCHARGE HOSE SUB-ASSEMBLY (See INSTALLATION )
CONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE (See INSTALLATION )
INSTALL V-RIBBED BELT (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
CHARGE REFRIGERANT (See REPLACEMENT )
WARM UP ENGINE (See REPLACEMENT )
INSPECT FOR LEAKAGE OF REFRIGERANT (See REPLACEMENT )
INSTALL REAR ENGINE UNDER COVER LH (for 2WD)
INSTALL ENGINE UNDER COVER (for 4WD)
INSTALL ENGINE UNDER COVER (for 2WD)
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
INSTALL V-BANK COVER (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.