Front Active Stabilizer Control Ecu: Installation

INSTALL FRONT ACTIVE STABILIZER CONTROL ECU
1. Install the ECU with the bolt and 2 nuts.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) for nut
  
  9.0 N*m (92 kgf*cm, 80 in.*lbf) for bolt
  
  Fig 1: Locating ECU Body Body Bolts And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using the procedures below, connect the ECU connectors.
  1. Connect the ECU connector. (*1)
  2. Rotate the lever in the direction of the arrow until a "click" sound is heard. (*2)
  3. Lock the lever's lock. (*3)
3. Install the ground wire to the ECU with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
4. Connect the wire harness clamp to the bracket.
  
  Fig 2: Connecting ECU Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 COOL AIR INTAKE DUCT
1. Install the intake duct with the 2 bolts.
INSTALL FRONT FENDER LINER RH
INSTALL FRONT FENDER WHEEL OPENING MOULDING RH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION

Fig 3: Locating Intake Duct And Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.