LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> GS 450h >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control >> Brake Control Power Supply >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake Control Power Supply: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 
    1. Remove the floor mat.
  3. REMOVE LUGGAGE COMPARTMENT NO. 1 TRIM COVER 
    1. Remove the trim cover.
  4. REMOVE ROPE HOOK ASSEMBLY 
    1. Remove the 2 bolts and 2 rope hooks.
  5. REMOVE REAR FLOOR FINISH PLATE 
    1. Remove the 3 clips and finish plate.
  6. REMOVE ROPE HOOK 
    1. Remove the 2 rope hooks.
  7. REMOVE LUGGAGE COMPARTMENT NO. 2 TRIM HOOK 
    1. Remove the 2 trim hooks.
  8. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER 
    1. Remove the 4 clips and trim cover.
  9. REMOVE SIDE LUGGAGE COMPARTMENT TRIM COVER RH 
    1. Remove the bolt and rope hook.
    2. Remove the 2 clips and trim cover.
  10. REMOVE BRAKE CONTROL POWER SUPPLY ASSEMBLY 
    1. Disconnect the connector.
    2. Remove the 3 nuts and brake control power supply.
    3. Remove the 4 bolts and 2 brackets.
      4. Fig 1: Locating Nuts And Brake Control Power Supply
      G05816445Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals