LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> GS 450h >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control >> Brake Pedal Stroke Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake Pedal Stroke Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH  (See REMOVAL )
  3. REMOVE CONSOLE UPPER PANEL ASSEMBLY  (See REMOVAL )
  4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  5. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  6. REMOVE FRONT DOOR OPENING TRIM COVER LH  (See REMOVAL )
  7. REMOVE INSTRUMENT SIDE PANEL LH  (See REMOVAL )
  8. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  9. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY  (See REMOVAL )
  11. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY 
    1. Disconnect the sensor connector.
    2. Remove the 2 nuts and sensor.
      3. Fig 1: Locating Brake Pedal Stroke Sensor Bolts
      G05816449Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals