LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> GS 450h >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control >> Skid Control Ecu >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Skid Control Ecu: Installation

  1. INSTALL SKID CONTROL ECU 
    1. Connect the 2 connectors and press the lock levers down to lock the connectors.
      NOTE: Make sure that the lock levers securely lock the connectors.
    2. Connect the connector.
      Fig 1: Pressing Lock Levers Down To Lock Connectors
      G05816440Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the ECU with the 3 bolts.

      Torque: 17 N*m (173 kgf*cm, 12 ft.*lbf) 

    4. Connect the connector indicated in the illustration.
      5. Fig 2: Locating Skid Control ECU Connector With Bolts
      G05816441Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  4. CHECK AND CLEAR DTC 
    1. Check and clear the DTCs (see DTC CHECK/CLEAR  ).
  5. PERFORM ZERO POINT CALIBRATION OF YAW RATE SENSOR 
    1. Perform the zero point calibration of the yaw rate sensor (see CALIBRATION  ).
  6. PERFORM LINEAR VALVE OFFSET LEARNING 
    1. Perform the linear valve offset learning (see INITIALIZATION  ).
scientia non olet · About LEMON Manuals