LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> GS 450h >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection & Installation >> Engine Coolant Temperature Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Coolant Temperature Sensor: Removal

  1. DISCHARGE FUEL SYSTEM PRESSURE  (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  3. REMOVE SERVICE PLUG GRIP  (See REMOVAL )
  4. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  5. REMOVE ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  6. REMOVE ENGINE ROOM SIDE COVER RH  (See REMOVAL )
  7. REMOVE V-BANK COVER  (See INSPECTION )
  8. REMOVE FRONT UPPER FENDER PROTECTOR LH  (See REMOVAL )
  9. REMOVE FRONT UPPER FENDER PROTECTOR RH  (See REMOVAL )
  10. REMOVE FRONT FENDER TO COWL SIDE SEAL LH  (See REMOVAL )
  11. REMOVE FRONT FENDER TO COWL SIDE SEAL RH  (See REMOVAL )
  12. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See REMOVAL )
  13. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See REMOVAL )
  14. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  15. DRAIN ENGINE COOLANT  (See COOLANT (FOR ENGINE) )
  16. DISCONNECT NO. 2 VENTILATION HOSE  (See REMOVAL )
  17. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE  (See REMOVAL )
  18. REMOVE THROTTLE BODY  (See REMOVAL )
  19. REMOVE INTAKE AIR SURGE TANK  (See REMOVAL )
  20. REMOVE INTAKE MANIFOLD  (See REMOVAL )
  21. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the sensor.
    3. Remove the gasket from the sensor.
      4. Fig 1: Locating Gasket For Sensor
      G05285367Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals