LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> GS 460 >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control >> Yaw Rate And Acceleration Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Yaw Rate And Acceleration Sensor: Removal

  1. REMOVE CONSOLE UPPER PANEL GARNISH FRONT  (See REMOVAL )
  2. REMOVE FRONT CONSOLE UPPER PANEL ASSEMBLY  (See REMOVAL )
  3. REMOVE CONSOLE BOX PLATE  (See REMOVAL )
  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  (See REMOVAL )
  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  6. REMOVE CONSOLE BOX REGISTER ASSEMBLY  (See REMOVAL )
  7. REMOVE CONSOLE BOX  (See REMOVAL )
  8. REMOVE CONSOLE BOX NO.2 DUCT 
    1. Remove the 2 clips and the console box No.2 duct.
      Fig 1: Locating Console Box No.2 Duct Clips
      G05297175Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE CONSOLE BOX NO.1 DUCT 
    1. Remove the clip and the console box duct No.1.
      Fig 2: Locating Console Box Duct No.1 Clip
      G05297176Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE YAW RATE SENSOR 
    1. Disconnect the yaw rate sensor connector.
    2. Separate the 2 wire harness clamps.
    3. Remove the 2 bolts and yaw rate sensor.
      NOTE: Do not remove the sensor from the bracket.
      Fig 3: Locating Bolts And Yaw Rate Sensor
      G05297177Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals