Floor Shift Assembly: Inspection

INSPECT TRANSMISSION CONTROL SWITCH

Connect the shift lever position switch connector.
Disconnect the transmission control switch connector of the shift lock control unit assembly.

Fig 1: Identifying Transmission Control Switch Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance according to the value(s) in the table below.

Standard Resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Shift Position	Tester Connection	Specified Condition
S, "+" and "-"	3 - 7	Below 1 Ω
Except S, "+" and "-"	↑	10 kΩ or higher
Press continuously "+" (Up shift)	2 - 5	Below 1 Ω
S	↑	10 kΩ or higher
Press continuously "-" (Down shift)	1 - 5	Below 1 Ω
S	↑	10 kΩ or higher

If the resistance value is not as specified, replace the transmission control switch.

Fig 2: Identifying Terminals Of Transmission Control Switch Connector