How To Proceed With Troubleshooting

HINT:

Troubleshoot in accordance with the procedures on the following pages

1. VEHICLE BROUGHT TO WORKSHOP 
2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK 
3. DTC CHECK 
   1. Check for DTCs and make a note of the code that is output.

      HINT:

      See DIAGNOSTIC TROUBLE CODE CHART .

   2. Delete the DTC
   3. Check if the DTC is output once again when the problem symptom is simulated based on the noted code

   Result 

   DTC OUTPUT RESULT
   
   

   Result	Proceed to
   No DTCs output	A
   DTCs output	B

   A: GO TO STEP  6

   B: Go to Next Step 

4. PROBLEM SYMPTOMS TABLE 

   HINT:

   See CUSTOMIZE PARAMETERS .

5. PERFORM TROUBLESHOOTING 
   1. Operation check.

      HINT.

      See OPERATION CHECK .

   2. Circuit inspection

      HINT.

      See REMOTE UP/DOWN FUNCTION DOES NOT OPERATE  to MANUAL UP/DOWN FUNCTION DOES NOT OPERATE ON DRIVER SIDE .

6. ADJUST, REPAIR OR REPLACE 
7. RESET POWER WINDOW MOTOR 
   1. If any of the power window switch illuminations is blinking, reset the power window for the switch with the blinking illumination.
      1. Turn the ignition switch ON.
      2. Open the door glass.
      3. Fully pull up the power window switch until the door glass is fully closed.
      4. Continue to hold the switch 1 second or more even after the door glass is fully closed.
      5. Check that the AUTO UP/DOWN function operates completely.

   NEXT: END