Inspection Procedure

1. Disconnect the skid control ECU (S38) connector.
2. Turn the ignition switch to the ON position.
3. Check that the BRAKE warning light comes on.

   OK: BRAKE warning light comes on. 

OK: REPLACE MASTER CYLINDER SOLENOID 

NG: Go to next step 

1. Disconnect the combination meter connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Specified Condition
   S38-3 (BRL) - C10-8	Below 1 Ω
   S38-3 (BRL) - Body ground	10 kΩ or higher

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (BRL CIRCUIT) 

Fig 1: Checking Harness And Connector (Skid Control ECU - Combination Meter)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: Go to next step 

1. Check the combination meter system (See HOW TO PROCEED WITH TROUBLESHOOTING ).

NG: REPLACE COMBINATION METER ASSEMBLY 

OK: END