Charging Systems: Charging: Generator: Disassembly

REMOVE GENERATOR REAR END COVER
1. Remove the 3 nuts and end cover.
  
  Fig 1: Identifying Generator Rear End Cover Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the terminal insulator.
REMOVE GENERATOR BRUSH HOLDER ASSEMBLY
1. Remove the rear seal plate from the brush holder.
2. Remove the 2 screws and brush holder.
  
  Fig 2: Identifying Brush Holder Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the front seal plate from the coil assembly.
REMOVE GENERATOR PULLEY
1. Hold SST (A) with a torque wrench, and tighten SST (B) clockwise to the specified torque.
  SST 09820-63011
  
  Torque: 39 N*m (400 kgf*cm, 29 ft.*lbf)
  
  Fig 3: Tightening SST (B) Clockwise To Specified Torque
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check that SST (A) is secured to the rotor shaft.
3. Mount SST (C) in a vise.
4. Insert SST (B) into SST (C), and attach the pulley nut to SST (C).
  
  Fig 4: Inserting SST (B) Into SST (C)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. To loosen the pulley nut, turn SST (A).
  NOTE: To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half of a turn.
  
  Fig 5: Turning SST To Loosen Pulley Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the generator from SST (C).
7. Turn SST (B), and remove SST (A and B).
  
  Fig 6: Turning SST (B) & Removing SST (A And B)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Remove the pulley nut and pulley.
REMOVE GENERATOR COIL ASSEMBLY
1. Remove the 4 bolts.
  
  Fig 7: Identifying Generator Coil Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, remove the coil assembly.
  SST 09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
  
  Fig 8: Using SST To Remove Coil Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the generator washer.
REMOVE GENERATOR ROTOR ASSEMBLY