Height Control Dryer: Installation

INSTALL HEIGHT CONTROL DRYER ASSEMBLY
1. Install the bolt, the dryer and a new O-ring.
  Torque: 6.4 N*m (65 kgf*cm, 57 in.*lbf)
2. Assemble the height control compressor, the dryer and the bracket as a unit to the vehicle, and tighten the 3 bolts to fix the bracket to the frame.
  Torque: 29 N*m (300 kgf*cm, 21 ft.*lbf)
3. Install the height control compressor assembly to the bracket with the 3 bolts.
  Torque: 5.9 N*m (60 kgf*cm, 52 in.*lbf)
  
  Fig 1: Identifying Height Control Compressor Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the connector.
CONNECT HEIGHT CONTROL TUBE NO. 2 (See INSTALLATION )
INSTALL HEIGHT CONTROL FILTER (See INSTALLATION )
INSTALL HEIGHT CONTROL COMPRESSOR COVER (See INSTALLATION )
CHECK AIR LEAK
HINT:

See ADJUSTMENT
INSTALL FUEL TANK FILLER PIPE PROTECTOR (See INSTALLATION )
INSTALL QUARTER PANEL MUDGUARD REAR LH
INSTALL REAR DISC WHEEL
Torque: 112 N*m (1,140 kgf*cm, 83 ft.*lbf)