Transmission Wire: Installation

1. Install the transmission wire with the bolt.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

2. Connect the transmission wire connector.
   Fig 1: Locating Transmission Wire Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the 7 connectors to the solenoid valves.
2. Install the clamp with the 2 bolts.

   Torque: 10 N*m (100 kgf*cm, 7 in.*lbf) for bolt A 

   11 N*m (110 kgf*cm, 8 in.*lbf) for bolt B 

   HINT.

   Each bolt length is indicated below.

   Standard bolt length: 

   36 mm (1.42 in.) for bolt A 

   12 mm (0.47 in.) for bolt B 

   Fig 2: Locating Connectors To Solenoid Valves

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the ATF temperature sensor.

   Sensor wire harness: 

   WIRE HARNESS SPECIFICATION
   
   

   Wire harness	Color
   for linear control	Orange
   for oil temp warning light	Blue

1. Install a new O-ring and the oil strainer with the 4 bolts.

   Torque: 10 N*m (100 kgf*cm, 7 ft.*lbf) 

HINT:

Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

Fig 3: Locating Oil Strainer Bolts

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the oil pan with the 20 bolts.

   Torque: 4.4 N*m (45 kgf*cm, 39 in.*lbf) 

HINT:

(See AUTOMATIC TRANSMISSION FLUID  )

HINT:

(See AUTOMATIC TRANSMISSION FLUID  )

Fig 4: Identifying Oil Pan Bolts

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002