LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS 250 AWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Engine Immobilizer >> Engine Immobilizer System >> ID Code Box Power Source Circuit >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

  1. INSPECT FUSE (SECURITY) 
    1. Remove the SECURITY fuse from the cowl side junction block RH.
    2. Measure the resistance of the fuse.

      Standard resistance: 

      Below 1 Ω 

    NG: REPLACE FUSE 

    OK: Go to next step 

  2. CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY) 
    1. Disconnect the J69 ECU connector.
    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage 

      VOLTAGE SPECIFICATION CHART

      Tester Connection Condition Specified Condition
      J69-1 (+B) - Body ground Always 10 to 14 V
      3. Fig 1: Identifying J69 ECU Connector
      G05831885Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: Go to next step 

  3. CHECK HARNESS AND CONNECTOR (ID CODE BOX - BODY GROUND) 
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      RESISTANCE SPECIFICATION CHART

      Tester Connection Condition Specified Condition
      J69-8 (GND) - Body ground Always Below 1 Ω
      2. Fig 2: Identifying ID Code Box Connector And J69 ECU Connector Terminal
      G05831886Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  

scientia non olet · About LEMON Manuals