LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS 250 AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control >> Yaw Rate And Acceleration Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Yaw Rate And Acceleration Sensor: Removal

  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission)  (See REMOVAL )
  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)  (See REMOVAL )
  3. REMOVE NO. 1 UPPER CONSOLE PANEL GARNISH (for Automatic Transmission)  (See REMOVAL )
  4. REMOVE NO. 2 UPPER CONSOLE PANEL GARNISH (for Automatic Transmission)  (See REMOVAL )
  5. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission)  (See REMOVAL )
  6. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)  (See REMOVAL )
  7. REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)  (See REMOVAL )
  8. REMOVE FRONT ASH RECEPTACLE SUB-ASSEMBLY  (See REMOVAL )
  9. REMOVE CONSOLE BOX REGISTER ASSEMBLY  (See REMOVAL )
  10. REMOVE CONSOLE BOX  (See REMOVAL )
  11. REMOVE NO. 2 REAR AIR DUCT (for Automatic Transmission) 
    1. Remove the 2 clips and the No. 2 rear air duct.
      Fig 1: Locating Clips And No. 2 Rear Air Duct
      G05319589Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE NO. 2 REAR AIR DUCT (for Manual Transmission) 
    1. Remove the clip and the No. 2 rear air duct.
      Fig 2: Locating Clips And No. 2 Rear Air Duct
      G05319590Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE YAW RATE AND ACCELERATION SENSOR 
    1. Disconnect the yaw rate and acceleration sensor connector.
    2. Separate the 2 wire harness clamps.
    3. Remove the 2 bolts and yaw and acceleration rate sensor.
      NOTE: Do not remove the sensor from the bracket.
      Fig 3: Locating Bolts And Yaw And Acceleration Rate Sensor
      G05319591Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals