Network Gateway Ecu: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL NETWORK GATEWAY ECU
1. Install the network gateway ECU
  
  Fig 1: Installing Network Gateway ECU
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 2 claws to install the cover.
3. Connect the connector
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (See INSTALLATION )
INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (See INSTALLATION )
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL SIDE INSTRUMENT PANEL (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM COVER
INSTALL FRONT DOOR SCUFF PLATE
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )