Front Speed Sensor: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT SPEED SENSOR
1. Wipe off sealant attached to the front speed sensor's fitting surface with a non-residue solvent.
  NOTE: Prevent foreign matter from attaching to the sensor rotor.
2. Install a new front speed sensor to the hub and bearing assembly The front speed sensor connector should be positioned upward
  
  Fig 1: Identifying Front Speed Sensor Connector Should Be Positioned Upward
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST and a press, install the front speed sensor onto the front axle hub and bearing
  SST 09214-76011
  NOTE:
  - Keep the front speed sensor away from magnets.
  - Do not use a hammer on the front speed sensor.
  - Check that there is no foreign matter such as iron chips on the front speed sensor's detecting portion.
  - Slowly press the front speed sensor straight.
    
    Fig 2: Identifying Skid Control Sensor
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT AXLE HUB SUB-ASSEMBLY WITH FRONT SPEED SENSOR (See INSTALLATION )
INSPECT FRONT AXLE HUB BEARING FOR LOOSENESS (See ON-VEHICLE INSPECTION )
INSPECT FRONT AXLE HUB FOR RUNOUT (See ON-VEHICLE INSPECTION )
INSTALL FRONT DISC (See INSTALLATION )
INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY (See INSTALLATION )
CONNECT FRONT SPEED SENSOR WIRE
1. Connect the front speed sensor wire to the front speed sensor.
  NOTE: Do not twist the sensor wire.
INSTALL FRONT WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)

Fig 3: Connecting Front Speed Sensor Wire To Front Speed Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
CHECK FOR SPEED SENSOR SIGNAL
HINT.

(See TEST MODE PROCEDURE )