On-Vehicle Inspection

1. Disconnect the J54 connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard voltage: 

   VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   J54-4 (IG+) - Body ground	Engine switch off	Below 1 V
   	Engine switch on (IG)	10 to 14 V
   J54-5 (ACC) - Body ground	Engine switch off	Below 1 V
   	Engine switch on (IG)	10 to 14 V
   J54-14(B)-Body ground	Always	10 to 14 V

   Fig 1: Identifying J54 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Measure the resistance according to the value(s) in the table below.

Standard resistance: 

HINT:

If the value is not as specified, repair or replace wire harness or connector.

1. Disconnect the J53 connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard voltage: 

   VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   J53-5 (ACC) - Body ground	Engine switch off	Below 1 V
   	Engine switch on (IG)	10 to 14 V
   J53-6 (B) - Body ground	Always	10 to 14 V
   J53-11 (IG+)-Body ground	Engine switch off	Below 1 V
   	Engine switch on (IG)	10 to 14 V

   Fig 2: Identifying J53 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Measure the resistance according to the value(s) in the table below.

Standard resistance: 

HINT:

If the value is not as specified, repair or replace the wire harness or connector.