On-Vehicle Inspection

INSPECT ACCELERATOR PEDAL

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream main switch ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / Accelerator Position No. 1 and Accelerator Position No. 2.
When depressing or releasing the accelerator pedal, check that the values of the Accelerator Position No. 1 and Accelerator Position No. 2 are within the specification.

Accelerator Position No. 1 standard voltage

ACCELERATOR POSITION NO. 1 STANDARD VOLTAGE

Condition	Specified Condition
Accelerator pedal is released	0.5 to 1.1 V
Accelerator pedal is depressed	2.6 to 4.5 V

Accelerator Position No. 2 standard voltage

ACCELERATOR POSITION NO. 2 STANDARD VOLTAGE

Condition	Specified Condition
Accelerator pedal is released	1.2 to 2.0 V
Accelerator pedal is depressed	3.4 to 5.0 V

If the result is not as specified, check the accelerator pedal, wire harness or ECM.