LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS 350 >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (2GR-FSE) - System And Component Testing, On-Vehicle Inspection, Removal, Inspection & Installation >> Crankshaft Position Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Installation

  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a coat of engine oil to an O-ring of the crankshaft position sensor.
    2. Install the crankshaft position sensor with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    3. Connect the crankshaft position sensor connector.
      4. Fig 1: Locating Crankshaft Position Sensor Connector And Bolt
      G05285361Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL COMPRESSOR WITH PULLEY ASSEMBLY  (See INSTALLATION )
  3. INSTALL DISCHARGE HOSE SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE  (See INSTALLATION )
  5. INSTALL V-RIBBED BELT  (See INSTALLATION )
  6. INSTALL REAR ENGINE UNDER COVER LH 
  7. INSTALL ENGINE UNDER COVER 
  8. INSTALL NO. 1 INLET AIR CLEANER  (See INSTALLATION )
  9. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  10. CHARGE REFRIGERANT  (See REPLACEMENT )
  11. WARM UP ENGINE  (See REPLACEMENT )
  12. CHECK FOR LEAKAGE OF REFRIGERANT  (See REPLACEMENT )
  13. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
scientia non olet · About LEMON Manuals