LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS 350 >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (2GR-FSE) - System And Component Testing, On-Vehicle Inspection, Removal, Inspection & Installation >> Knock Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Knock Sensor: Installation

  1. INSTALL KNOCK SENSOR 
    1. Install the 2 knock sensors so that they are horizontal as shown in the illustration. Then install the 2 bolts.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

      HINT:

      It is acceptable for the sensor to be tilted +10° to - 5°.

    2. Connect the 2 knock sensor connectors.
    Fig 1: Locating Knock Sensors Connector
    G05285394Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FUEL INJECTOR SEAL  (See INSTALLATION )
  3. INSTALL INJECTOR  (See INSTALLATION )
  4. INSTALL NO. 1 FUEL DELIVERY PIPE  (See INSTALLATION )
  5. INSTALL NO. 2 FUEL DELIVERY PIPE  (See INSTALLATION )
  6. INSTALL NO. 3 FUEL PIPE  (See INSTALLATION )
  7. INSTALL NO. 2 FUEL PIPE  (See INSTALLATION )
  8. INSTALL FUEL PUMP ASSEMBLY  (See INSTALLATION )
  9. CONNECT NO. 2 FUEL PIPE  (See INSTALLATION )
  10. INSTALL NO. 1 FUEL PIPE  (See INSTALLATION )
  11. INSTALL FUEL PRESSURE PULSATION DAMPER  (See INSTALLATION )
  12. INSTALL WATER HOSE JOINT  (See INSTALLATION )
  13. INSTALL INTAKE MANIFOLD  (See INSTALLATION )
  14. INSTALL INTAKE AIR SURGE TANK ASSEMBLY  (See INSTALLATION )
  15. INSTALL THROTTLE BODY  (See INSTALLATION )
  16. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE  (See INSTALLATION )
  17. CONNECT NO. 2 VENTILATION HOSE  (See INSTALLATION )
  18. ADD ENGINE COOLANT  (See ON-VEHICLE INSPECTION )
  19. INSPECT FOR COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  20. INSPECT FOR FUEL LEAK  (See ON-VEHICLE INSPECTION )
  21. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See INSTALLATION )
  22. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH  (See INSTALLATION )
  23. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH  (See INSTALLATION )
  24. INSTALL FRONT WIPER ARM HEAD CAP  (See INSTALLATION )
  25. INSTALL ROOF DRIP SIDE FINISH MOLDING LH 
  26. INSTALL ROOF DRIP SIDE FINISH MOLDING RH 
  27. INSTALL FRONT FENDER PROTECTOR UPPER LH  (See INSTALLATION )
  28. INSTALL FRONT FENDER PROTECTOR UPPER RH  (See INSTALLATION )
  29. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  30. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  31. INSTALL ENGINE ROOM SIDE COVER RH  (See INSTALLATION )
  32. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  33. CHECK FUNCTION THROTTLE BODY  (See INSTALLATION )
scientia non olet · About LEMON Manuals