Section 15 (Charging System): Generator: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL GENERATOR
1. Using an E8 "TORX" socket wrench, set the generator with the 2 stud bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 1: Locating Generator Stud Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the generator with the 2 bolts and 2 nuts.
  Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
  
  Fig 2: Locating Generator Bolts And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the wire harness bracket with the nut
  Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
  
  Fig 3: Locating Wire Harness Bracket Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the harness to the +B terminal with nut A.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
5. Install the oil cooler tube with bolt B.
  Torque: 14 N*m (140 kgf*cm, 10 ft.*lbf)
6. Connect wire harness clamp C.
7. Connect generator connector D.
INSTALL FRONT STABILIZER BAR
1. Install the front stabilizer bar (See INSTALLATION ).
  
  Fig 4: Locating Oil Cooler Tube Bolt And Generator Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL WIRE HARNESS
1. Connect the wire harness with the bolt and clamp
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
  
  Fig 5: Locating Ground Cable Clamp And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL V-RIBBED BELT (See INSTALLATION )
INSTALL RADIATOR RESERVE TANK ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER CASE SUB-ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
INSTALL REAR ENGINE UNDER COVER LH
INSTALL REAR ENGINE UNDER COVER RH
INSTALL ENGINE UNDER COVER
INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
INSTALL FRONT WHEELS
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).