Steering Angle Sensor: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING ANGLE SENSOR
1. Align the locating pins, engage the 6 claws and install the steering angle sensor to the spiral cable.
INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR (See INSTALLATION )
INSTALL STEERING COLUMN COVER (See INSTALLATION )

Fig 1: Identifying Claws Of Steering Angle Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADJUST SPIRAL CABLE (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY (See INSTALLATION )
INSTALL STEERING PAD (See INSTALLATION )
INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION )
INSTALL LOWER NO. 3 STEERING WHEEL COVER (See INSTALLATION )
INSPECT STEERING WHEEL CENTER POINT
1. Inspect the steering wheel center point.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (See INITIALIZATION )
INSPECT STEERING PAD (See INSTALLATION )
INSPECT SRS WARNING LIGHT
HINT.

(See DIAGNOSIS SYSTEM )