LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS 350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Brake Control / Dynamic Control Systems) >> Yaw Rate And Acceleration Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Yaw Rate And Acceleration Sensor: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH  (See REMOVAL )
  4. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH  (See REMOVAL )
  5. REMOVE CONSOLE PANEL SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE FRONT ASH RECEPTACLE ASSEMBLY  (See REMOVAL )
  7. REMOVE REAR ASH RECEPTACLE ASSEMBLY  (See REMOVAL )
  8. REMOVE CONSOLE BOX REGISTER ASSEMBLY  (See REMOVAL )
  9. REMOVE CONSOLE BOX  (See REMOVAL )
  10. REMOVE NO. 2 CONSOLE BOX DUCT  (See REMOVAL )
  11. REMOVE YAW RATE AND ACCELERATION SENSOR 
    1. Separate the 2 wire harness clamps.
    2. Remove the 2 bolts and yaw rate and acceleration sensor.
      Fig 1: Locating Bolts And Yaw Rate And Acceleration Sensor
      G05752710Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the yaw rate and acceleration sensor connector.
      NOTE: Do not remove the sensor from the bracket.
      Fig 2: Locating Yaw Rate And Acceleration Sensor Connector
      G05752711Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals