Steering Pad Switch: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING PAD SWITCH ASSEMBLY
1. Engage the 2 claws and install the steering pad switch.
2. Install the screw.
  
  Fig 1: Identifying Steering Pad Switch Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Engage the 2 claws and install the steering pad switch.
4. Install the screw.
5. Connect the connector to the spiral cable.
  
  Fig 2: Identifying Steering Pad Switch Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Connect the cruise connector and install the connector clamp.
  
  Fig 3: Identifying Pad Switch Connector Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING PAD (See INSTALLATION )
INSTALL LOWER NO. 3 STEERING WHEEL COVER (See INSTALLATION )
INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the Cable is reconnected (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )