Inspection Procedure

1. Check if the Bluetooth settings are correct

   OK: Bluetooth settings are correct. 

NG: SET SETTINGS CORRECTLY 

OK: Go to Next Step 

1. Check if the cellular phone is Bluetooth compatible

   HINT.

   Some versions of Bluetooth compatible cellular phones may not function.

   OK: The phone is Bluetooth compatible. 

NG: END (ONLY A BLUETOOTH COMPATIBLE CELLULAR PHONE CAN BE USED) 

OK: Go to Next Step 

1. Check if the cellular phone functions

   HINT.

   The cellular phone is unable to call under any of the following conditions

   • The cellular phone is locked
   • The directory is being transferred.
   • The line is crossed
   • Transmission is regulated
   • The power is off
   • The cellular phone is not connected to Bluetooth ("BT" is displayed while connected)

     OK: None of the above conditions exist. 

NG: SET SETTINGS CORRECTLY 

OK: Go to Next Step 

1. Check if the cellular phone can make a call

   HINT.

   When the battery is low, calls cannot be made or received

   OK: Cellular phone can make a call. 

NG: REPAIR OR REPLACE CELLULAR PHONE 

OK: Go to Next Step 

1. Set the cellular phone so that it can receive calls
2. Place the cellular phone close to the multi-display
3. Check if the cellular phone has reception according to the multi-display

   OK: Cellular phone has reception. 

NG: REPLACE MULTI-DISPLAY  (See REMOVAL  )

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )