Steering Lock System: Initialization
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
HINT
In vehicles equipped with the push-button start function, the starting function may not be operational after recharging or while jump-starting a discharged battery. This condition is most likely to occur if battery voltage drops below 9 V The following procedure has been developed to address this condition
- INITIALIZATION PROCEDURE
- Confirm that the D/C CUT fuse is installed.
HINT
If the D/C CUT fuse is not installed, install it at this time.
- Move the shift lever to P.
- Turn the engine switch off
- Open the driver's door.
HINT
Opening the driver's door will start an initialization process between the steering lock ECU and the engine room junction block.
- Depress the brake pedal.
- Press the engine switch.
- Confirm that the D/C CUT fuse is installed.