Inspection Procedure

NOTE: If the ID code box (immobilizer code ECU) is replaced, register the ECU code and ECU communication ID (See REGISTRATION ).

CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY)

Measure the voltage according to the value (s) in the table below

Standard Voltage

VOLTAGE SPECIFICATION

Tester Connection	Condition	Specified Condition
J69-1 (+B) - Body ground	Always	11 to 14 V

Fig 1: Identifying J69 Connector Terminal

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE

OK: Go to next Step

CHECK HARNESS AND CONNECTOR (ID CODE BOX - BODY GROUND)

Measure the resistance according to the value (s) in the table below.

Standard Resistance

RESISTANCE REFERENCE

Tester Connection	Condition	Specified Condition
J69-8 (GND) - Body ground	Always	Below 1 Ω

Fig 2: Identifying J69 Connector Terminal

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )