Inspection Procedure
NOTE:
When replacing the skid control ECU, perform zero point calibration and store system information (See CALIBRATION
).
- CHECK PART NUMBER (ECM)
- Check that the part number of the installed ECM is correct.
OK: ECM installed in the vehicle has the correct part number.
NG: REPLACE ECM (for 2UR-GSE) (See REMOVAL )
OK: Go to next step
- Check that the part number of the installed ECM is correct.
- CLEAR AND STORE SYSTEM INFORMATION
- Clear the system information (See CALIBRATION )
- Store the system information (See CALIBRATION )
- RECONFIRM DTC
- Clear the DTCs (See DTC CHECK / CLEAR ).
- Check if the same DTC is recorded (See DTC CHECK / CLEAR
)
Result
RESULT REFERENCEResult Proceed to DTC (C1203/59) is not output A DTC (C1203/59) is output B
B: REPLACE SKID CONTROL ECU (See REMOVAL )
A: CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (See DIAGNOSIS SYSTEM )