Inspection Procedure

1. Check if a CAN communication system DTC is output (See DIAGNOSIS SYSTEM )

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B: INSPECT CAN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

A: Go to next step 

1. Check if a multiplex communication system DTC is output (See DIAGNOSTIC TROUBLE CODE CHART )

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B: INSPECT MULTIPLEX COMMUNICATION SYSTEM  (See DIAGNOSTIC TROUBLE CODE CHART )

A: Go to next step 

1. Connect the Techstream to the DLC3
2. Turn the engine switch on (IG)
3. Select the Active Test mode on the Techstream (See DATA LIST / ACTIVE TEST  )

   ABS/VSC/TRAC 

   CONTROL RANGE REFERENCE
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   VSC Warning Light	Master caution indicator light and multi-information display	Indicator ON/OFF	Observe combination meter

4. Check that the master caution indicator light and multi-information display on the combination meter turns on or off in accordance with the Techstream operation

   OK: The master caution indicator light and multi-information display turns on or off in accordance with the Techstream operation. 

   HINT.

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE  )

NG: Go to step 4 

OK: REPLACE SKID CONTROL ECU  (See REMOVAL  )

1. Turn the engine switch off.
2. Perform the Active Test of the combination meter (meter CPU) using the Techstream (See DATA LIST / ACTIVE TEST )
3. Check the combination meter

   OK: The master caution indicator light and multi-information display turns on or off in accordance with the Techstream operation. 

   HINT:

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step (See PROBLEM SYMPTOMS TABLE  )

NG: REPLACE COMBINATION METER ASSEMBLY  (See REMOVAL )

OK: REPLACE SKID CONTROL ECU  (See REMOVAL  )