Satellite Switch: Inspection

INSPECT SATELLITE SWITCH

Measure the resistance according to the value(s) in the table below

Standard Resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Switch Condition	Specified Condition
2 (LSEL) - 5 (E)	Satellite switch LH is pressed	Below 1 Ω
2 (LSEL) - 5 (E)	Satellite switch LH is not pressed	10 kΩ or higher
3 (SET)- 5 (E)	Satellite switch ON/OFF is pressed	Below 1 Ω
3 (SET) - 5 (E)	Satellite switch ON/OFF is not pressed	10 kΩ or higher
4 (RSEL) - 5 (E)	Satellite switch RH is pressed	Below 1 Ω
4 (RSEL) - 5 (E)	Satellite switch RH is not pressed	10 kΩ or higher

HINT.

If the value is not as specified, replace the satellite switch (See REMOVAL )

Fig 1: Identifying Satellite Switch