Engine Oil Cooler: Installation

INSTALL ENGINE OIL COOLER
1. Clean the oil cooler contact surface on the cooler mounting.
2. Apply a light coat of engine oil to a new O-ring.
3. Install a new O-ring to the oil cooler.
4. Install the oil cooler with the union bolt, bolt and new gasket.
  Torque: Union Bolt
  
  59 N*m (602 kgf*cm, 43 ft.*lbf)
  
  Bolt
  
  10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 1: Identifying Bolt, Gasket, Union Bolt And Oil Cooler
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the 2 water by-pass hoses.
Fig 2: Locating Water By-Pass Hoses
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADD ENGINE OIL (See OIL AND OIL FILTER )
ADD ENGINE COOLANT (See REPLACEMENT )
CHECK ENGINE OIL LEVEL (See LUBRICATION SYSTEM )
INSPECT FOR OIL LEAK
INSTALL ENGINE UNDER COVER
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )