Inspection Procedure

HINT

• DTC P2610 is set if an internal ECM problem is detected Diagnostic procedures are not required ECM replacement is necessary
• Read freeze frame data using the Techstream The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

1. REPLACE ECM 
   1. Replace the ECM (See REMOVAL )
2. CHECK WHETHER DTC OUTPUT RECURS 
   1. Connect the Techstream to the DLC3
   2. Turn the engine switch on (IG)
   3. Turn the Techstream ON
   4. Clear DTCs (See DTC CHECK/CLEAR )
   5. Start the engine and wait for 10 minutes or more
   6. Enter the following menus" Powertrain / Engine / Trouble Codes / Pending
   7. If no pending DTC is displayed, the repair has been successfully completed

   NEXT: END