Service Data
2UR-GSE STARTING - SERVICE DATA
| Starter assembly | Standard current 190 A or less at 11.5 V |
| Starter armature assembly | Standard resistance Segments - Segments Below 1 Ω Armature - Commutator 10kΩ or higher |
| Standard diameter 35.0 mm (1.378 in) Minimum diameter 34.0 mm (1.339 in) Standard undercut depth 0.7 mm (0.028 in) Minimum undercut depth 0.2 mm (0.008 in) Maximum commutator's runout 0.05 mm (0.0020 in) |
|
| Starter yoke assembly | Standard resistance Lead wire - Field coil Below 1 Ω Reid coil end - Field frame 10 kΩ or higher |
| Brush length | Standard length 15.0 mm (0.590 in) Minimum length 10.0 mm (0.394 in) |
| Starter brush holder assembly | Standard resistance Positive brush holder - Negative brush holder 10 kΩ or higher |
| Standard spring installed load 21.5 to 27.5 N (2.2 to 2.8 kgf, 4.8 to 6 2 lbf) |
|
| Starter magnetic switch assembly | Standard resistance Terminal 50 - Terminal C Below 1.0 Ω Terminal 50 - Switch body Below 2.0 Ω |
| Starter relay | 3-5.10 kΩ or higher 3-5 Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
| Starter cut relay | 3-5 10 kΩ or higher 3-5 Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
| Engine switch | Pushed 7 (SS1) - 5 (GND) Below 1 Ω Pushed 2 (SS2) - 5 (GND) Below 1 Ω Not pushed 7 (SS1) - 5 (GND) 10 kΩ or higher Not pushed 2 (SS2) - 5 (GND) 10 kΩ or higher |