LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS F >> Repair and Diagnosis >> Steering >> Power Steering >> Power Assist Systems >> Power Steering System >> Freeze Frame Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Freeze Frame Data

  1. FREEZE FRAME DATA 
    NOTE:
    • It is difficult to show the specified values (judgement values) clearly because freeze frame data values change significantly due to differences in measurement conditions, surroundings, or vehicle conditions. For this reason, there may be a problem even when the values are within specifications.
    • Turn the engine switch on (IG) and park the vehicle on level ground. Check the freeze frame data by using the Techstream.
    1. Turn the engine switch off.
    2. Connect the Techstream to the DLC3
    3. Turn the engine switch on (IG)
    4. Turn the Techstream on
    5. Check the freeze frame data by following the prompts on the Techstream Enter the following menus. Chassis / EMPS / Trouble Codes

    EMPS 

    MEASUREMENT ITEM/RANGE NORMAL CONDITION CHART

    Tester Display Measurement Item/Range Inspection Condition Reference Value
    Meter Vehicle Velocity Vehicle speed from meter/
    Min 0 km/h (0 mph)
    Max 300 km/h (186 4 mph)    		 Vehicle is stopped 0 km/h (0 mph)
    Vehicle is driven at a constant speed No significant fluctuation
    Engine Revolution Engine revolution/
    Min 0 rpm
    Max 12800 rpm    		 Engine is running at a constant speed No significant fluctuation
    Motor Actual Current Amount of current to motor/
    Min -327 68 A
    Max 327 67 A    		 Power steering is in operation Value changes in proportion to steering effort
    Command Value Current Demanded amount of current to motor/
    Min -327 68 A
    Max 327 67 A    		 Power steering is in operation Value changes in proportion to steering effort
    Steering Angle Velocity Steering angle speed/
    Min -327 68deg/s
    Max 327 67deg/s    		 Steering wheel is turned Value changes in proportion to steering speed
    Thermistor Temperature ECU substrate temperature/
    Min -40°C (-40°F)
    Max 150°C (302°F)    		 Engine switch on (IG) -
    PIG Power Supply Power source voltage to activate motor/
    Min 0 V
    Max 20 1531 V    		 Power steering is in operation 11 to 14 V
    IG Power Supply ECU power source voltage/
    Min 0 V
    Max 20 1531V    		 Engine switch on (IG) 11 to 14 V
    Torque Sensor 1 Output Torque sensor 1 rotation angle/
    Min 0 deg
    Max 1441 77 deg    		 Steering wheel is turned Value changes from 0 to 360° every 3° of steering angle
    Torque Sensor 2 Output Torque sensor 2 rotation angle/
    Min 0 deg
    Max 1441 77 deg    		 Steering wheel is turned Value changes from 0 to 360° every 3° of steering angle
    TRQ1 Zero Point Value Zero point value of torque sensor 1/
    Min 0 deg
    Max 1441 77 deg    		 Steering wheel is not turned (without load) Value differs depending on vehicle
    TRQ2 Zero Point Value Zero point value of torque sensor 2/
    Min 0 deg
    Max 1441 77 deg    		 Steering wheel is not turned (without load) Value differs depending on vehicle
    Motor Rotation Angle Motor rotation angle/
    Min 0 deg
    Max 1441 77 deg    		 Steering wheel is turned Value changes from 0 to 360° every 3° of steering angle
    Command Val Current 2 Demanded amount of current to motor 2/
    Min -327 68 A
    Max 327 67 A    		 - -
    PIG2 Voltage Motor drive voltage after pressurizations/
    Min 0 V
    Max 45 955 V    		 Power steering is in operation 27 to 34 V
    Motor Voltage Motor power source voltage/
    Min 0 V
    Max 45 955 V    		 Power steering is in operation 27 to 34 V
    Motor Terminal Volt (U) Motor terminal voltage (U phase)/
    Min 0 V
    Max 46 667 V    		 Power steering is in operation 0 to 34 V
    Motor Terminal Volt (V) Motor terminal voltage (V phase)/
    Min 0 V
    Max 46 667 V    		 Power steering is in operation 0 to 34 V
    Motor Terminal Volt (W) Motor terminal voltage (W phase)/
    Min 0 V
    Max 46 667 V    		 Power steering is in operation 0 to 34 V
    PS Assist Signal Power steering assist signal/ ON or OFF Engine switch on (IG) -
scientia non olet · About LEMON Manuals